Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Convergence issues in time dependent moving mesh simulation

Please login with a confirmed email address before reporting spam

Hi all,

I'm simulating the evaporation of a sessile droplet (2D-axisymmetric model). The droplet is very hydrophilic and has a very small contact angle (picture attached). The coupled physics are:

1. Transport of Diluted Species (evaporation flux normal to the curved surface, no flux on bottom, symmetry on side)
2. Deformed Geometry (to simulate the evaporation; droplet is shrinking normal to its curved surface and is allowed to move in the r-direction, not the z-direction)

The model does not converge in time-dependent simulations due to the poor mesh quality in the sharp angled region.

I've tried refining the mesh at the point, refining the mesh in a boxed region around and near the point, played with mesh size & distribution settings along the curve/near the point, and even experimented with boundary layer meshes (something I still don't fully understand).

Strangely, the addition of boundary layers allowed the model to run for at least 60 seconds (goal: 500 seconds) until inverted mesh elements become damaging and stop the simulation.

I am aware that creating a fillet at the tip and/or changing the geometry to increase the contact angle may alleviate these mesh issues but what if that is not possible? If I want to simulate this very hydrophilic scenario, what is the best route to take? Perhaps I am still not too familiar with mesh size settings. I am also wondering why a boundary layer mesh setting along the curved surface slightly improved my model.

Any help will be very much appreciated.

Many thanks in advance,
Alex


0 Replies Last Post 2013年1月28日 GMT-5 18:18
COMSOL Moderator

Hello Alexander Sinkevich

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.