Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cauchy Stress

Please login with a confirmed email address before reporting spam

hi
I´m modeling a plate. In the results branch I configurated a 2D plot to show "the Second Piola-Kirchhoff stress, xx component" using the expresion "plate.Sxx".
I want to know if it's possible to configurate a Cauchy stress component in the 2D plot.

Regards.

2 Replies Last Post 2013年1月14日 GMT-5 02:42
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年1月12日 GMT-5 15:28
Hi

The Cauchy stress is the stress in the Eulerian representation check for the "spatial stress tensor"
The second Piola-Kirchhoff (or material) stress is in the Lagrangian representation, these are dissociated, in particular for "geometric non-linearity enabled"

Check carefully the doc and use the right Frame for your integrations (see the doc ;)

--
Good luck
Ivar
Hi The Cauchy stress is the stress in the Eulerian representation check for the "spatial stress tensor" The second Piola-Kirchhoff (or material) stress is in the Lagrangian representation, these are dissociated, in particular for "geometric non-linearity enabled" Check carefully the doc and use the right Frame for your integrations (see the doc ;) -- Good luck Ivar

Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年1月14日 GMT-5 02:42
As long as the analysis is geometrically linear, 2nd P-K and Cauchy stresses are the same.

If you have a geometrically nonlinear problem, the interpretation of a Cauchy stress would still be problematic, since it has fixed directions in space, and there would thus be stress components not aligned with the deformed plate.

Regards,
Henrik
As long as the analysis is geometrically linear, 2nd P-K and Cauchy stresses are the same. If you have a geometrically nonlinear problem, the interpretation of a Cauchy stress would still be problematic, since it has fixed directions in space, and there would thus be stress components not aligned with the deformed plate. Regards, Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.