Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Temperature obtained Higher than Reference

Please login with a confirmed email address before reporting spam

I have checked geometries, material used and boundary conditions. All are same but I am only not able to model the heating part properly. I am getting high temparature than in reference paper.

The paper I am following is this: Numerical and outdoor experimental study on active snow melting of conductive rubber composites in roads https://doi.org/10.1080/14680629.2022.2103020

Here is my COMSOL model, please find the file attached.



0 Replies Last Post 2023年10月6日 GMT-4 11:43
COMSOL Moderator

Hello Anup Jwala Poudel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.