Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comparison between numerical solution and Analytical expression - model verification

Please login with a confirmed email address before reporting spam

Dear Comsol Engineer:

How to make a transient model more accurate, how to output the real results, is it the reason for the time step of the solver? I am verifying the validity of the model. Although the trend of the results calculated by the two methods is consistent, the time when the numerical simulation solution and the Analytical expression reach the steady state is different, and the corresponding results of the numerical solution and the Analytical expression at different times are slightly different.

If you have any suggestions, I would greatly appreciate them.


0 Replies Last Post 2023年6月20日 GMT-4 04:32
COMSOL Moderator

Hello Tao Zhou

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.