Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inkjet nozzle - Level set method simulation

Please login with a confirmed email address before reporting spam

Hi Everyone,

I am in the process of simulating an inkjet nozzle - Level set method simulation of an experimental 3D Printing nozzle. The input of the printer is given as triple pulse waveform. I have finalised the boundary conditions and input pulse as Pulse Voltage - (150, 120, 90) V , Pulse Length - (20,20,20)μs Pulse delay - (9,9,9)μs . Input velocity - 0.56[m/s] * rect1 t[1/s]. Time step (0,1e-8,1e-6) s. I have attached the results for your kind reference.

There is no error or warning. But I am getting air inside the inlet nozzle in the volume fraction plot. In actual case the fluid (water) should get ejected from the throat but in my case it is ejecting from the throat but inside the nozzle there is an air gap. Could anyone help me in this regard ?



0 Replies Last Post 2023年5月29日 GMT-4 09:09
COMSOL Moderator

Hello Priya Palanivel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.