Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to fix the error "Out of memory in stationary solver."

Please login with a confirmed email address before reporting spam

hi !
I'm Lam, I construct a model.when i play function 'compute' in STUDY and see error "Out of memory in stationary solver." please show me how to fix it. thank you for comment.

4 Replies Last Post 2012年10月20日 GMT-4 14:22

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年10月9日 GMT-4 05:25

The straightforward advice would be: Plug in more memory! If you can't do that, you can try a coarser mesh or reduce the complexity of your model.

Cheers
Edgar
The straightforward advice would be: Plug in more memory! If you can't do that, you can try a coarser mesh or reduce the complexity of your model. Cheers Edgar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年10月11日 GMT-4 02:40
thank you very much
thank you very much

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年10月12日 GMT-4 04:14
There may be problem in your boundary conditions. check it up
There may be problem in your boundary conditions. check it up

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年10月20日 GMT-4 14:22
hi!
thanks for comment.
can you tell me about boundary condition?
hi! thanks for comment. can you tell me about boundary condition?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.