Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Force Measurement

Please login with a confirmed email address before reporting spam

Hello, I am working on the simulation of the surface force measurement with the tip of cantilever beam. However after the basic design is done, the force measurement in the electrosatic function gives an error.


2 Replies Last Post 2021年7月27日 GMT-4 08:31
Dave Greve Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年7月14日 GMT-4 20:26

There doesn't seem to be any electrostatic problem to solve, as there are no voltages or charges.

Maybe you had better explain what problem you are trying to solve.

There doesn't seem to be any electrostatic problem to solve, as there are no voltages or charges. Maybe you had better explain what problem you are trying to solve.

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年7月27日 GMT-4 08:31
Updated: 3 years ago 2021年8月9日 GMT-4 08:20

There doesn't seem to be any electrostatic problem to solve, as there are no voltages or charges.

Maybe you had better explain what problem you are trying to solve.

>There doesn't seem to be any electrostatic problem to solve, as there are no voltages or charges. > >Maybe you had better explain what problem you are trying to solve.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.