Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

hole on block

Posted 2020年1月4日 GMT-5 16:41 Fluid & Heat, Geometry, Modeling Tools & Definitions Version 5.5 5 Replies

Aroub Alkharashi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

how can I make two holes on left and right side of block? please I need a detailed explanation. Thanks

5 Replies Last Post 2020年1月8日 GMT-5 23:54
Aroub Alkharashi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年1月4日 GMT-5 16:51

I'm working on 3D geom. kindly help

I'm working on 3D geom. kindly help
Moin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年1月4日 GMT-5 21:41

Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.

-------------------
Moin
Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.
Aroub Alkharashi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年1月6日 GMT-5 07:17

Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated.

actually i need box empty inside..... can I build the box by let the material of the block is air?

>Interesting question. Did you try cubic beizer under more primitives in Geometry tab? Please keep us updated. actually i need box *empty inside*..... can I build the box by let the material of the block is air?
Aroub Alkharashi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年1月7日 GMT-5 09:39

I did it! pleas take a look :)

I did it! pleas take a look :)

Attachments:

Moin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年1月8日 GMT-5 23:54

Good job!

-------------------
Moin
Good job!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content