Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Adoptation and error estimate

Please login with a confirmed email address before reporting spam

Hello dear, I am trying to model a high mach number flow and as a part of that I want to use adaptation and error estimates in the stationary solver for refinement of the mesh where it is needed, however I face with aproblem which I cannot understand. In "Adaptation and error estimates" section in "Stationary solver" I used "L2 norm of error squared" and for refinement method I used either "Longest" or "Regular", and for both of these choices I changed the "Element growth rate" from "1.7" to any number (Lower or Higher). But no matter I changed this number after solving and showing the refined mesh in the Mesh section, the element growth rate which used to refine is "1.7". I wonder why this number stay constant however I change it. Thanks in advance. Best regards, Saleh


0 Replies Last Post 2019年3月26日 GMT-4 04:55
COMSOL Moderator

Hello Saleh. Aghajani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.