Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error in Periodic boundary condition for a composite

Please login with a confirmed email address before reporting spam

Hi,

I am using comsol 4.0a to implement periodic boundary condition for a composite. I applied the PBC through establishing boundary similarities and then using pointwise constraints on the boundary. It gives me an error stating that the extrusion coupling failed: no source point found.

Can anyone please elaborate what does this error mean and how to overcome this?

Thanks a lot.

Best
Lakshmi.

2 Replies Last Post 2011年10月8日 GMT-4 09:52

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年10月6日 GMT-4 01:12
Hi,

Maybe you have set the constraint on the source boundary. You should only do it for the destination boundary where the linear extrusion operator is defined.

Hope this helps.
Hossein
Hi, Maybe you have set the constraint on the source boundary. You should only do it for the destination boundary where the linear extrusion operator is defined. Hope this helps. Hossein

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年10月8日 GMT-4 09:52
Hi,

Thanks for your reply. I did not impose the point-wise constraint on the source boundary. But I found a way to make it work with periodic boundary conditions itself by editing the equations related to it.

Thanks.

Best
Lakshmi.
Hi, Thanks for your reply. I did not impose the point-wise constraint on the source boundary. But I found a way to make it work with periodic boundary conditions itself by editing the equations related to it. Thanks. Best Lakshmi.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.