Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Solution Convergence Error, Phase Change in Rotating Mould using Moving Mesh

Please login with a confirmed email address before reporting spam

Hello,
I am facing problem in modeling a rotating mold filled with polymer powder that is being heated continuously. However my solution is not converging. The solver error is "LAST TIME STEP DID NOT CONVERGE".
Kindly help me figure out the error. I tried changing parameter values but to no avail.

Please help.

-Raghav

1 Reply Last Post 2011年10月9日 GMT-4 13:36
COMSOL Moderator

Hello Raghav Bansal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Ashok Kumar Nallathambi

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年10月9日 GMT-4 13:36
better you can upload the .mph file...so that i can help you....
better you can upload the .mph file...so that i can help you....

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.