Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

probe measurement - urgent

Nikhil Valsan Kulangareth

Please login with a confirmed email address before reporting spam

I am stuck with my simulation in usage of probes. Can anyone help me to understand the difference between point probe, and edge probe? How are the measurements performed in both these cases? Is there any reference material regarding these? I need to know in particular if I place a point source inside a cube and measure the potential using doamin point probe and domain edge probe, how are the readings recorded in both these case? How the the probes estimates these values.

Thanks in advance


0 Replies Last Post 2018年11月2日 GMT-4 10:49
COMSOL Moderator

Hello Nikhil Valsan Kulangareth

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.