Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Change the position of the force

Please login with a confirmed email address before reporting spam

Hello,

The problem I try to solve is following.

I have a solid block with circular curve on face boundary. Then I define a force starting in point 5 (see attached file) in radial direction (which is Z direction in Point 5). Now with time changing I need to change the position of the force along the circular curve, keeping the radial direction. So it may look like clock arrow moving in YZ plane, for specific time my force pointing in radial direction but moving along the curve.

The robust way to do it is to define lots of points on the curve and step function, so that for specific time force will be acting only in one point.

But I bet there should be more clever solution.

I hope the problem is clear enough.

Attached is a model file.

Thank you.

Artem


1 Reply Last Post 2011年4月28日 GMT-4 16:22
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年4月28日 GMT-4 16:22
Hi

here is one way (model in v4.1.0.185), but I have a little issue with the normalisation of the gaussian ;)

--
Good luck
Ivar
Hi here is one way (model in v4.1.0.185), but I have a little issue with the normalisation of the gaussian ;) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.