Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

View/show boundary conditions

Please login with a confirmed email address before reporting spam

Hi

When applying boundary conditions to a geometry is often useful to view the applied boundary conditions. In Comsol 3.5 there was a button to toggle this feature on and off but I can't find this feature in Comsol 4.0. Can someone give me an hint.

Regards,

Per

1 Reply Last Post 2010年11月10日 GMT-5 03:43
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010年11月10日 GMT-5 03:43
Hei Per

Well from my understanding it's not in V4.0, havent found it yet in 4.1 neither ;)
but I'm almost sure it will come it's too handy, hovewer probably not at highest priority level by COMSOL

--
Good luck
Ivar
Hei Per Well from my understanding it's not in V4.0, havent found it yet in 4.1 neither ;) but I'm almost sure it will come it's too handy, hovewer probably not at highest priority level by COMSOL -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.