Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

RF metal/semi conductor simulation problems

Posted 2010年10月29日 GMT-4 12:18 0 Replies

Rob Allan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

First off I am new to Comsol and in no way an expert.

I am trying to perform a 2D simulation of a layered structure of metal on top of silicon which is then on top of silicon dioxide. I can perform simulations using microwave frequencies, 5+GHz, but when I reduce the frequency to ~10MHz I get no propagation of the wave. I know this isn't physical but why does the simulation stop working at lower frequencies? Or is it not working at all?!

Any advice would be very gratefully received.

Thank you
Rob
0 Replies Last Post 2010年10月29日 GMT-4 12:18
COMSOL Moderator

Hello Rob Allan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content